Changing The Front And Rear Turn Indicator Bulbs; Changing The Tail Light Bulb; Replacing The Number Plate Bulb - MOTO GUZZI GRISO 1100 Manual

PARKING LIGHT BULB
CAUTION
To extract the bulb holder, do not pull
the electric wires.
u Grasp the parking light (7) bulb holder
and pull to extract.
u Withdraw the bulb (2) and replace it with
one of the same type.
u Make sure the bulb is correctly located in
the bulb holder.
2
7
2
3
CHANGING THE FRONT AND REAR
TURN INDICATOR BULBS
Carefully read page 75 (BULBS).
u Place the vehicle on the stand, see page
50 (PUTTING THE VEHICLE ON THE
STAND).
u Unscrew and remove the screw (1).
CAUTION
While removing the lens, proceed
carefully in order not to break the
locating peg.
u Remove the lens (2).
CAUTION
M a k e s u r e t h a t t h e l e n s l o c a t e s
correctly into its seat on refitting.
Tighten the screw (1) moderately and
carefully, to avoid damaging the lens.
u Press the bulb (3) slightly and rotate it
anticlockwise.
Extract the bulb (3) from its seat.
u
Insert the bulb into the bulb holder, so
that the two pins slide into the slots in
the holder.
u Fit a new bulb of equal rating.
1
4
If the bulb holder (4) comes off, refit it
into its seat so that the chamfered
opening of the holder matches the hole
for the screw.

CHANGING THE TAIL LIGHT BULB

This vehicle fits a LED tail light, have it
replaced by a Moto Guzzi Authorised
Dealer.
REPLACING THE NUMBER PLATE
BULB
Since this operation is quite complex, have
it performed by a Moto Guzzi Authorised
Dealer.
CAUTION
CAUTION
use and maintenance Griso 77