Installing Hot Swap Drive Cage; Attaching Chassis Fans; Installing Raid Controller - Intel SMALL BUSINESS SERVER Manual

1. Connect IDE cable from optical drive to the mainboard IDE connector (J).
2. Connect slimline USB floppy drive to USB 6 (R) connector on the mainboard.
3. Attach cables from Front Panel cable to Front Panel header (Q) on the mainboard.
4. Attach front side USB port cable to the USB 4-5 connector (O) on the mainboard.

Installing Hot Swap Drive Cage

1. Unpack hot swap drive cage AXX6SCSIDB
2. Unpack hot swap drive cage installation kit AP3HSDBKIT
3. Follow steps 7 thru 13 (pages 4-8) described in Hot Swap Drive Conversion Kit Install
Guide, which is included in the box with APP3HSDBKIT
4. Slide the drive cage into the drive bay slot on the chassis. You should hear a click when the
blue plastic retention mechanism locks into place. Be sure to feed the fan cable through the
slot first so that it exits through the back of the drive cage. Be sure to place IDE cable (from
optical drive to the mainboard) between the hot swap drive cage and processor air duct, so
that it does not interfere with fans.

Attaching Chassis Fans

See mainboard Quick Start User's Guide for connector locations on the mainboard.
1. Attach rear chassis fan to System Fan 6 connector (C) on the mainboard before re-installing
rear system fan assembly.
2. Re-install rear system fan assembly (see Step 12 in chassis Quick Start User's Guide)
3. Attach drive cage fan to System Fan 1 connector (N) on the mainboard

Installing RAID Controller

1. Unpack the RAID controller SRCSU41L
2. Unpack the Battery Backup Unit AXXRBBU2
3. Connect the wire from the battery to the connector on the battery circuit board. See letter A
in the figure below.
4. Position the battery backup unit over the RAID card, lining up the connectors. See letter B
in the figure below.
5. Press the battery backup unit onto the RAID card.
6. Turn over the RAID card / battery backup unit assembly.
7. Use the three screws included with the battery backup unit to secure the battery backup unit
to the RAID card.
8. Install RAID Controller into PCI-X slot 4 (3
- 16 -
rd
from FB_DIMM slots) on the mainboard.