HYOSUNG TE 100 Manual page 52

CAUTION
The 『 『 TE100 /9 0』 』 should be transpo-
rted or deposited in the normal position.
If the 『 『 TE100 /9 0』 』 be transported or
deposited in the standing position,
bleed air of oil pump.
Air bleeding of oil pump
① ① Loosen the air bleeding screw at the
engine idles.
② ② Wait until the air bleeds out from the
air bleeding screw completely.
③ ③ Tighten the screw after air bleeding
of oil pump.
Before transporting the 『 『 TE100 / 90』 』 , , drain
the fuel from the carburetor as follows :
1. Turn the fuel cock lever to the "OFF"
position.
2. Drain fuel from the carburetor into a
suitable container by loosening the
carburetor drain bolt.
3. When the fuel has drained completely,
retighten the drain bolt.
When draining the carburetor, always
shut the engine off. Do not smoke, and
never drain or refuel in an area where
there are open flames or sparks.
Be sure to use a suitable container to
catch the fuel you drain from the
carburetor. Do not allow the fuel to spill
or you may create a fire hazard. Keep
fuel out of the reach of children and pets
or they may be injured, and dispose of
unwanted fuel properly.
When transporting the 『 『 TE100 /9 0』 』 ,
lock the parking brake and tie down the
vehicle securely with rope or some
other suitable means. Use extra tie
downs when you transport the vehicle
in the standing position. Failure to
properly secure the vehicle may result in
an accident or damage to the vehicle.
★ ★ STARTING THE 『 『 TE100
/ 90』 』 AFTER TRANSPORT
To feed fuel into the carburetor, turn the
fuel cock to the "ON" position.
52
WARNING
WARNING
WARNING