HYOSUNG TE 100 Manual page 44

◉ ◉ Tire Tread Condition
WARNING
Operating the vehicle with excessively
worn tires can cause skidding due to
decreased traction. It is recommended
that the front and rear tires be replaced
when the depth of the tire tread is 3 mm
(0.118 in) or less.
◉ ◉ Tire Pressure
A low pressure gauge is provided in tool kit
under the seat, so you can measure the air
pressure in your 『TE100 / 90』tires. Check
the air pressure in all tires before each use
of the vehicle. Improper air pressure can
affect handling, maneuverability, traction,
tire life and rider comfort. Be sure that the
tires are inflated to the pressures shown
below. Tire pressure should only be
measured or adjusted when the tires are
cold, or misleading measurements can
result.
COLD TIRE PRESSURE
FRONT
REAR
Using a high pressure air pump to fill the
tires can be hazardous.
If too much air is put into a tire, the tire
may burst, causing severe injury. Use a
manual type air pump to fill the tires.
44
25 KPa
0.25 ㎏/㎠
3.6 psi
25 KPa
0.25 ㎏/㎠
3.6 psi
CAUTION