HYOSUNG TE 100 Manual page 51

■ ■ IGNITION SYSTEM CHECK
1. Remove the spark plug and reattach it to
the spark plug lead.
2. While holding the spark plug firmly
against the engine, push the starter
switch with the engine stop switch in the
" "position and the remote engine
stop switch cap is installed on the remote
engine stop switch. If the ignition system
is operating properly, a blue spark should
jump across the spark plug gap. If there
is no spark, take your machine to you
authorized HYOSUNG dealer.
WARNING
Do not check for a spark unless you are
certain that you know how to do it ; you
could get a high voltage electrical
shock. When testing for a spark, do not
point the spark plug near the spark plug
hole. There may be some fuel inside the
cylinder which could be ignited. Due to
the possibility of electrical shock,
anyone with a heart condition or
pacemaker should avoid this check.
★ COMPLAINT : Engine stalls
1. Make sure there is enough fuel in the
fuel tank.
2. Check to see that the spark plug is not
fouled. Remove the plug and decarbon
or replace it, if necessary.
3. Make sure the fuel cock is clear. Also
check connected to the fuel tank cap is
not clogged.
T R A N S P O RT I N G
The 『TE100 / 90』should be transported in
the normal position.
[NORMAL POSITION]
If the 『 『 TE100 /9 0』 』 be transported or
deposited in the standing position, it
may air income in the oil pump.
This may cause severe cylinder and
piston damage which may not be bleed
air of the oil pump.
[STANDING POSITION]
51
CAUTION