HYOSUNG TE 100 Manual page 40

�
To change the oil :
1. place the vehicle on level ground.
2. Remove the oil filler cap ①.
3. Remove the oil drain plug ③ from the
bottom of the engine and drain the oil
completely.
4. Reinstall the drain plug ③.
5. Remove the clutch cover.
6. Remove the level screw ② and pour
fresh oil of the specified type through the
filler hole until the oil flows out from the
oil level hole.
TRANSMISSION OIL CAPACITY
Replace
Overhaul
7. Refit the oil filler cap ① and oil level
screw ②.
�
80 ㎖
90 ㎖
40
CAUTION
Frequent use in wet conditions will
require more frequent oil changes. If the
vehicle becomes submerged in water,
immediately change the oil.
Failure to follow these instruction may
result in severe transmission damage.
ENGINE OIL LEVEL
The engine oil tank is located under the
seat. Check the oil level each time before
starting the engine. If the oil level is low, fill
up the tank with the specified oil. The oil
tank holds 1.0ℓ
WARNING
Never operate the 『 『 T E 1 0 0 / 9 0』 』
without an adequate amount of oil, if the
engine runs out of oil, it can stop
suddenly, causing injury and/or severe
mechanical damage.