HYOSUNG TE 100 Manual page 46

◉ ◉ Inspect Drive Chain Slack
5~15mm
(0.197~0.591 in)
The slack in the drive chain to 5~15mm
(0.197~0.591 in).
If exceed 15mm (0.591 in) of the drive
chain slack, replace the drive chain with a
new one.
WARNING
Failure to inspect the drive chain slack
before each use of the vehicle could be
hazardous. Too much chain slack could
cause the chain to come off the
sprockets, resulting in an accident or
serious damage to the vehicle.
Inspect the drive chain slack before
each use.
FRONT AND REAR WHEEL
①
1. Place the vehicle on level groud and set
the parking brake.
2. Loosen the three wheel nuts ① on the
wheel to be removed.
3. Lift up the front or rear end of the vehicle
by placing a jack or block under the axle
or frame.
4. Remove the three wheel nuts.
5. Remove the wheel. To reinstall the
wheel, reverse these steps.
When replacing a wheel, it is very
impotant that the wheel nuts be torqued
to the proper specifications. If they are
not, the wheel can come off unexpec-
tedly. We strongly recommend that you
have these nuts checked and retorqued,
if necessary, by your authorized
HYOSUNG dealer.
Tighten Torque
Front and Rear
wheel nut
46
REMOVAL
WARNING
25 N∙m
(2.5㎏∙m)