HYOSUNG TE 100 Manual page 21

③
②
① Switch body
② Rubber cap
③ Remote engine stop switch lanyard
The switch consists of a rubber cap fitted
over a plastic body. When the rubber cap is
in place, the engine can operate. When the
rubber cap is removed from the switch
body, the engine cannot be started. If the
engine is running and the rubber cap is
removed by pulling the lanyard attached to
the cap, the engine will stop running.
To use the remote engine stop switch :
1. Fit the rubber cap on the engine of the
lanyard over the remote engine stop
switch body located on the rear end of
the vehicle as shown.
2. Put your fingers through the loop at the
other end of the lanyard.
①
21
3. With the lanyard fastened to the vehicle
and to your hand, follow after the moving
vehicle. If you notice any driving hazard
or unsafe situation, pull the lanyard
forcefully so that the rubber cap comes
off.
This will activated the remote engine
stop switch, stopping the vehicle
engine.
WARNING
When the remote engine stop switch
cap is pulled off, the engine will stop
running.
The vehicle will continue to roll for some
distance, however. Remember this
when judging when to operate the
remote engine stop switch.
WARNING
If you do not put your fingers through
the loop in the lanyard, it may slip from
your grasp unexpectedly. This could
make it impossible for you to stop the
engine in an unsafe situation.
'
s