HYOSUNG TE 100 Manual page 50

Proper lubrication is important for safe,
smooth operation and long life of each
working part of your vehicle. Pay attention
to the need for lubrication when you
perform periodic maintenance on the
vehicle. Be sure to have your authorized
HYOSUNG dealer perform a general
lubrication as shown in the maintenance
chart on page 34.
Your authorized HYOSUNG dealer will
lubricate such items as wheel bearings,
rear axle housings, steering shaft holder,
etc.
T RO U B L E S H O OT I N G
CAUTION
It is best to consult your H Y O S U N G
dealer before attempting to troubleshoot
any problem. Damage may result from
inappropriate repairs or adjustments.
Such damage may not be covered
under warranty.
This troubleshooting guide is provided to
help you identify the cause of some
common complaints.
★ COMPLAINT : Engine is
hard to start or does not
start at all.
Something is probably wrong with the fuel
system or ignition system.
■ ■ FUEL SYSTEM CHECK
1. Make sure there is adequate fuel in the
fuel tank.
2. Check that the engine stop switch is in
the " " position.
3. Check that the remote engine stop
switch cap is installed on the remote
engine stop switch.
4. Make sure there is enough fuel reaching
the carburetor from the fuel tank.
a. Loosen the drain screw which is
located under the carburetor and
drain the fuel from the carburetor.
Do not allow the fuel to spill; catch the
fuel in a container. Do not allow any fuel
to come in contact with the hot engine
or exhaust system. Extinguish any
smoking materials before performing
this check, and stay away from any
open flames or heat sources.
b. Tighten the drain screw.
c. Remove the spark plug.
d. Loosen the drain screw and check
that the carburetor is filled back up
with fuel.
e. If it has been determined that fuel is
reaching the carburetor, the ignition
system should be checked next.
50
WARNING