Table of Contents
Advertisement
Introduction
Viewing Still Images | Viewing Movies | [o] Viewing Images Automatically as a Slideshow (slideshow) | [O] Viewing Multiple Images | [INFORMATION] Viewing Image Information | [J]/[I] Erasing Unwanted
Images | [U] Protecting Images from Accidental Erasing (PROTECT) | [p] Adding Voice Messages to Still Images (POSTRECORDING) | [V] Resizing and Trimming Images (RESIZE) | [W] Rotating an Image |
[T] Using DPOF to specify print settings | [G] Printing by Connecting the Camera Directly to a Printer (PictBridge) |
Deleting the Device (Windows 98 and Windows 98SE only)
If the driver software is not installed successfully, the PC will be unable to
recognize the camera.
If this occurs, use the procedure below to delete the device. Then use the
procedure on p.135 to re-install the drivers.
* Note that this procedure is only required for Windows 98 and Windows
98SE.
1
Insert the memory card into the camera.
(
p.21)
2
Load batteries into the camera.
3
Connect the camera to your PC using the USB cable provided
and then start up the PC.
A Important
Contents (Top page)
Detailed Contents
Getting Ready
Taking Pictures
Check the size of the USB connectors. Plug the small connector into the camera and
the large connector into the USB port on your PC.
Index
Playback
Connecting to a Windows PC
GB-142
Nomenclature
Set Up
| Connecting to a Macintosh
BACK
NEXT
Menus and Settings
Troubleshooting
Hide quick links:
Advertisement
Table of Contents
