Messages And Responses - Kyocera M410R User Manual

Introduction
Troubleshooting

Messages and Responses

Message
MEMORY CARD FULL
NO CARD
WRITE PROTECT
CARD ERROR or
UNSUPPORTED
FORMAT
NO IMAGE
FF CLOSE
ZOOMING ERROR
CANNOT SHOOT
PRINTER ERROR
Contents (Top page) Detailed Contents
Getting Ready Taking Pictures
There is not enough recording
space available on the memory
card.
There is no memory card inserted.
The SD memory card is write-
protected.
You are using a card that was
formatted on another device.
The format of the memory card is
not compatible with this camera.
The card is not inserted correctly.
Nothing is recorded on the memory
card.
The flash has not been popped up.
The camera was turned on with the
lens cap still attached.
Camera malfunction or fault.
You are using bracketing and there
is not enough available space on
the memory card.
The printer is not ready to print.
An error was detected in the
connection to the printer.
Index
Playback
Cause
GB-174
Nomenclature
Set Up
Response
Insert a new memory card or
erase some unwanted images.
Insert a memory card.
Remove the write-protection for
the card ( p.22) or use another
memory card.
Format the memory card in the
camera. ( p.151)
Insert a new memory card or
format this memory card.
Re-insert the memory card.
Insert a memory card that has
been used to take pictures, or
shoot images.
Pop the flash up.
Remove the lens cap and turn the
camera on, taking care not to
touch the lens as you do so.
Turn the camera on and off
several times. If this does not
correct the problem, contact a
Kyocera/Yashica Service Center
and request repairs.
Insert a new memory card or
erase some unwanted images.
Check that the printer is ready to
print. Refer to the instructions
provided with the printer for
details.
Reconnect to the printer and then
try again.
BACK
Menus and Settings Troubleshooting