Installing Or Removing The Optical Drive; Installing The Optical Drive; Figure 31. Removing Drive Bracket From The Server System - Intel SR2520SAXSR - Server System - 0 MB RAM User Manual

Installing or Removing the Optical Drive

Cautions: The optical drive is NOT hot swappable. Before removing or replacing the drive, you must
first take the server out of service, turn off all peripheral devices connected to the system,
turn off the system by pressing the power button, and unplug the AC power cord from the
system or wall outlet.

Installing the Optical Drive

1. Observe the safety and ESD precautions at the beginning of this book. See
Information".
2. Power down the server and unplug all peripheral devices and the AC power
cable(s).
3. Remove the front bezel if it is installed. For instructions, see
Bezel".
4. Remove the server system cover. For instructions, see
Cover".
5. Remove the front panel. For instructions, see
6. Remove the four screws holding the drive bracket to the server system (see letter
"A" in the figure below), and remove the bracket from the system (see letter "B" in
the figure below).
44

Figure 31. Removing Drive Bracket from the Server System

"Replacing the Front Panel
A
B
®
Intel Server System SR2520SA User's Guide
"Safety
"Removing the Front
"Removing the System
Board".
AF001825