DAELIM NS125DLX Service Manual page 145

●If the brake bleeder is not used, do the following.
●First, fill the brake fluid up to the upper limit line.
Connect the hose to the bleeder valve to receive
brake fluid.
① Squeeze the brake lever completely loosen the
bleeder valve 1/2 turn, and tighten it again.
NOTE
•Do not release the brake lever until the bleeder
valve is tightened.
② Release the brake lever slowly to its fullest
extent, and leave it unattended for a few
seconds.
③ Repeat the process specified in item ① and ②
until there is no more air bubbles coming out
of the bleeder valve.
● Check the fluid level often, and add fluid if the
fluid level is near the lower level.
● If no air leaks out of the bleeder hose, operate the
brake lever to check the presence of air.
● Assemble the bleeder valve.
0.4-0.7kgf· · m
Torque:
● Add brake fluid up to upper level. Install
diaphragm and mater cylinder cap.
Torque value: 0.1-0.2kgf· · m
Rear brake
● Change in the same method as that of front brake
fluid changing.
● Bleed in the same method as that of front brake
air bleeding.
Brake Pad
Front brake pad replacement
NOTE
•When replacing brake pads, replace whole set.
•Do not remove the brake hose when replacing
brake pads.
● Open the lock plate tangs, and loosen the pad pin
bolt.
Bleeder valve
Rear mater cylinder
Fixing Bolt
Brake System
Bleeder hose
Rear brake caliper
14-3