DAELIM NS125DLX Service Manual page 121

Steering Handle
Removal
● Remove the following parts.
- Back mirror
- Front cover (⇨ 4-3)
- LH. RH. Front handle side cover
- Front handle cover
-Remove the speedometer cable from the
speedometer.
- Rear handle cover
● Loosen the front master cylinder holder bolts,
remove the front master cylinder.
● Loosen the rear master cylinder holder bolts,
remove the rear master cylinder.
CAUTION
•Support master cylinders properly to prevent
brake fluid from leaking
•If the master cylinders are dropped upside down,
air may enter the hydraulic system. Fix it to the
vehicle while maintaining the correct assembled
location.
● Loosen the throttle housing fixing screw, remove
the upper/under housing.
● Remove the throttle cable from the throttle grip,
remove the throttle grip from the steering handle.
● Remove the FR./RR. brake hose, speedometer
cable, throttle cable from the handle cable guide.
● Loosen the handle setting bolt and U-nut.
● Remove the steering handle from the steering
stem.
Installation
● Install the steering handle to the steering stem.
● Install the handle setting bolt and U-nut.
Torque values: 5.0kgf m(50N.m, 36ft-lb)
NOTE
•When installing the handle setting collar, match it
with the groove accurately.
Front Wheel/Front Fork/Steering
Front master cylinder
Trottle grip Upper/under housing
Screw
Rear master cylinder
Setting bolt
12-3