DAELIM NS125DLX Service Manual page 125

● Remove the right side collar.
● Remove the dust seal and brake disk.
● Check the disk for defects. (⇨ 14-5)
Wheel bearing replacement
● Install the bearing remover head and the remover
shaft on the wheel, and remove the bearing and
distance collar.
NOTE
• Always replace bearings in pairs, and never use
old bearings.
Tools: Bearing remover head
Bearing remover
● Apply sufficient amount of grease to the bearing.
● Insert the right bearing with its seal surface facing
outside.
● Do not tilt the bearing. Insert accurately.
● Upon assembling the distance collar, insert the
left bearing with its seal surface facing outside.
Tools: Driver
Attachment,
Pilot, 15mm
32× × 35mm
Front Wheel/Front Fork/Steering
Right side collar
Dust Seal
Distance collar
Brake disk
Bearing
12-7