DAELIM ET-250 Service Manual page 91

Install drive shaft.
Special tool:
Drive shaft puller
Drive shaft and oil seal install bush
Clutch nut wrench
Apply with grease onto new drive shaft oil seal lip,
and then install the oil seal.
Special tool:
Drive shaft and oil seal install bush
Install drive shaft bearing setting plate (1 bolt).
Gear box side
Use inner bearing puller to remove the final shaft
needle bearing, gear shift shaft bearing and counter
shaft bearing from the cover inner side.
Special tool:
Inner bearing puller
Remove cir clip of final shat out side bearing.
.
Clutch nut wrench
Drive shaft and
seal install bush
Cir clip
Drive shaft and
seal install bush
Drive shaft puller
Inner bearing puller