DAELIM ET-250 Service Manual page 82

Installation of Clutch OUTER/Driven Pulley
Oil seal
Assembly
Install new oil seal and O-ring onto mo vable driven
face.
Apply with specified grease to lubricate the inside of
movable driven face.
Specified grease
O-ring
Install the movable driven face onto driven face.
Install the guide pin and guide pin roller.
Movable driven face
Guide pin
Oil seal
Install the collar.
O-ring Guide pin
Guide pin roller
Collar
Install friction plate, spring and clutch weight into
clutch spring compressor, and press down the
assembly by turning manual lever until mounting nut
that can be installed.
Hold the compressor by bench vise and tighten the
mounting nut to specified torque with clutch nut
wrench.
Remove the clutch spring compressor.
Torque value: 5.0~6.0kgf-m
Install clutch outer/driven pulley and drive belt onto
drive shaft.
Clutch nut wrench
Clutch spring compressor