Gear Oil - DAELIM ET-250 Service Manual

4-7 Gear Oil

Gear Oil Change
Gear oil join bolt
Remove oil join bolt.
Remove drain bolt and drain gear oil out.
Install the drain bolt after drained.
Torque value : 1.0~1.5kgf-m
Make sure that the drain bolt washer can be re-used.
Add oil to specified quantity from the join hole.
Gear Oil Quantity: 650c.c. when replacing
Make sure that the join bolt washer can be re-used,
and install the bolt.
Start engine and run engine for 2-3 minutes.
Turn off engine and make sure that oil level is in
correct level.
Make sure that no oil leaking.
Gear oil drain bolt