DAELIM ET-250 Service Manual page 120

Loosen the radiator 4 bolts.
Remove coolant upper side pipes.
Remove coolant outlet pipe.
Disconnect the couplers for the thermo switch and fan
motor, and then remove radiator and cooling fan.
Disassembly
Loosen the 3 bolts from the fan duct, and then remove the
fan duct.
Loosen 3 screws from the fan motor, and take off the fan
motor.
Remove nut to remove the fan from fan motor.
Assembly
Install fan motor onto fan duct and insert the fan into the
motor shaft.
Apply a coat of the adhesive to the shaft thread of the
motor, and then install the washer and the lock nut.
Tighten the fan duct onto the radiator with 3 bolts. Please
refer to chapter 17 for the inspection of the thermo switch.
Caution
Liquid packing must be applied to the
thermo switch before installing to
avoid damaging the radiator.
Installation
Install the removed parts in the reverse order of removal.
Install radiator in the reverse order of removal.
Upon completion, check for any leakage.
4 bolts
Coolant outlet pipe
Cooling fan
motor screws x3
Fan nut
Coolant inlet pipe
Thermo switch coupler
Cooling fan
duct bolts x3
Thermo switch