Electric Starter; Light Bulbs Replacement - DAELIM ET-250 Service Manual

CHARGING
Firstly, connect the charged positive cable to the battery
positive terminal. Secondly, connect the charged negative cable to the
battery
negative terminal.
Using 0.9A-charging current about 11 hours. (Normal charging)
Or using 4A-charging current about 3 hour. (Quick charging)
Keep flames and sparks away from a battery being charged.
Quick charging should be limited to an emergency;
Normal charging is preferred.

17.5 ELECTRIC STARTER

Information
If a battery has not work a period of time, the voltage may
reduce and may not provide enough power to starter motor.
If a battery is in a good condition, but engine can not be start.
Please go back to service.
TROUBLESHOOTING
Starter Motor Turns Slowly
Weak battery.
Poorly connected starter motor cable.
Failed starter motor.
Poorly connected battery ground cable.
Starter Motor Cannot Work
Engine stop switch at "off "position.
Gearshift bar is not at neutral position.
Check for a blown fuse near battery.
Make sure that the battery is fully charged and in good condition.

17.6 LIGHT BULBS REPLACEMENT

HEADLIGHT & Front Direction lights
To remove the headlight, please loosen three screws at
back of the headlight.
After loosen these three screws, users can find a connector.
Please disjoin the connector in order to replace an electrical
bulb conveniently and safely. The steps show on pictures.
Installation is in the reverse order of disassembly.
Head light