Back Panel - Cisco WAP4410N - Small Business Wireless-N Access Point Administration Manual

Getting to Know the Wireless-N Access Point

Back Panel

Back Panel
WAP4410N Wireless-N Access Point with Power Over Internet
The ports of the access point are located on the back panel of the switch.
RESET Button—There are two ways to reset the access point to the factory
default configuration. Either press the Reset button for approximately 10 seconds
or restore the defaults using the web-based utility of the access point.
ETHERNET Port—Connects to Ethernet network devices, such as a switch or
router that may or may not support PoE.
POWER Port—Connects the access point to power using the supplied 12VDC
power adapter.
3
7