Cisco WAP4410N - Small Business Wireless-N Access Point Administration Manual page 41

Configuring the WAP4410N Wireless-N Access Point
Wireless
!
CAUTION
STEP 1
STEP 2
STEP 3
STEP 4
WAP4410N Wireless-N Access Point with Power Over Internet
Configuring WPA-Enterprise Security
The WPA-Enterprise mode features WPA used in coordination with a RADIUS
server for client authentication.
Use this mode only when a RADIUS server is connected to the access point.
To enable wireless WPA-Enterprise security, follow these steps:
Click Wireless > Security.
From the Security Mode drop-down menu, select WPA-Enterprise.
To enable wireless isolation within the SSID, click Enabled.
Provide the following information:
•
Primary/Backup RADIUS Server—Enter the IP address of the RADIUS
server. The Backup Radius server is used only if the primary server is
unavailable.
•
Primary/Backup RADIUS Server Port—Enter the port number used by the
RADIUS server. The default is 1812. The backup Radius server is used only
if the primary server is unavailable.
6
32