Back Panel Description - Cisco DPH650 User Manual

Back Panel Description

The following illustration describes the back panel components of the DPH650.
Note: Image may vary from actual product and specifications.
1 CABLE - F-Connector connects to an active cable signal from your service
provider.
2 WIRELESS SETUP - —Allows you to add new wireless devices to the wireless
network of the DPH650.
3 ETHERNET - Bridged 10/100 Mbps Ethernet port with 802.11g wireless access
point. It supports 10/100BASE-T connections.
4 RESET - Reset-to-Default Momentary Switch (Factory Reset)
Note: This button is for maintenance purposes only. Do not use unless told to do
so by your service provider.
5 POWER - Connects the Access Point to the 12 VDC output of the AC power
adapter that is provided with your Access Point. Only use the AC power adapter
and power cord that is provided with your Access Point.
4027494 Rev A
CAUTION:
Avoid damage to your equipment. Only use the AC power adapter and power
cord that is provided with your AP.
Back Panel Description
13