Cisco WAP4410N - Small Business Wireless-N Access Point Administration Manual page 50

Configuring the WAP4410N Wireless-N Access Point
Wireless
STEP 1
STEP 2
STEP 3
STEP 4
WAP4410N Wireless-N Access Point with Power Over Internet
Enabling Local Connection Control
To enable local connection control for your access point, follow these steps:
Click Wireless > Connection Control.
Click Local.
There are two ways to control the connection (association) of wireless client
devices. You can either prevent specific devices from connecting to the access
point, or you can allow only specific client devices to connect to the access point.
The client devices are specified by their MAC addresses. The default is to allow
only specific client devices.
To add a MAC address to the connection control list, click Wireless Client List.
In the window that appears, select a MAC address to add to the connection
control list.
You can also manually add MAC addresses to the connection control list by
entering these addresses in the MAC 01–20 fields.
Click Save.
6
41