To turn these on follow the steps below.
1. Select Configuration/Setup -> System Event and Error Log. The following
screen will be displayed.
Figure 4-25 System Event and Error Log
2. Set either all or a subset of the logs to be enabled to suit your desired
outcome.
3. Press Esc, then save your settings.
4.1.6 Diagnostic utility
The ROM-based diagnostics package can be started from the EFI Firmware
Boot Manager menu by selecting the Diagnostic Utility. It is also possible to
start this from the MemMap file system command prompt by typing amidiag (in
our example, it was fs1:).
The Diagnostic utility looks similar to the IA-32 ROM version.
121
Chapter 4. Installation