Post-Setup Phase - IBM 88553RX Installation Manual

Windows Server 2003, Datacenter Edition Setup
==================================================
The partition you selected is not formatted. Setup will now
format the partition.
Use the UP and DOWN ARROW keys to select the file system
you want, and then press ENTER.
If you want to select a different partition for Windows,
press ESC.
Format the partition using the NTFS file system (Quick)
Format the partition using the FAT file system (Quick)
Format the partition using the NTFS file system
Format the partition using the FAT file system
Figure 4-44 Formatting screen
Choose an option then follow the instructions to complete the text-mode portion
of the installation.
At the end of the text-mode portion, a new Windows entry is added to the EFI
Firmware Boot Manager menu. After you restart the system at the end of
text-mode setup, the entry is launched automatically. (If Windows does not boot
automatically, select it from the EFI Firmware Boot Manager menu.)
GUI setup
Complete the standard Windows Server 2003 installation as per the instructions
on the screen and those provided in the product documentation. This is similar to
the installation of Windows 2000/2003 on IA-32 platforms.

4.3.4 Post-setup phase

Once Windows has been installed, you should perform the following steps.
Installing additional drivers
Specific device drivers are available for the x455 that are not included with the
base operating system. Drivers that you should obtain separately for the
operating system include:
Broadcom Ethernet controller
Remote Supervisor Adapter service processor
IBM Eserver xSeries 455 Planning and Installation Guide
144