Fujitsu 6240 - fi - Document Scanner Operator's Manual page 194

7.2 Document Quality
file:///D|/Documents%20and%20Settings/scanner/Desktop/Lynx3/06/contents/EN/07/c07_02_01.htm (3 of 3)9/28/2007 2:38:43 PM
It is recommended that the front side of the card be placed face down in the
Automatic Document Feeder.
The card to be scanned should be within the ISO7810 compliance, type ID-1.
Dimensions: 3.4 inch (height) x 2.1 inch (width)/ 86 mm x 54 mm
Thickness: 0.056 inches / 1.4 mm or less
Material: PVC (Poly vinyl chloride) or PVCA (Polyvinyl chloride acetate)
Note: Before scanning your card, test with a dummy card of the same material to
see if it can be fed into the ADF properly.
Cards that are excessively rigid or less flexible may not feed smoothly and excessive
noise may occur.
Note: If the cards do not feed smoothly, try:
- Scanning one card at a time.
- Enabling [Automatic Paper Size Detection]. For how to configure this setting, see
Section "3.10 Correcting Skewed
- Raising the resolution.
Cards should be clean from oil and without labels.
Cards cannot be scanned when the imprinter is installed.
All Rights Reserved. Copyright 2007 © PFU LIMITED
Documents."