Table of Contents
Advertisement
rack. As a last resort, a minimum of four people could remove the server. If only two
people are available, remove power supplies, disk drives, and system controller to
reduce the weight to about 50 pounds before removing the server. See below.
▼ To Remove the Server From the Rack
1. If you need to lighten the server, you can remove following from the rack:
a. Power supply units:
b. Cable management assembly:
iii.
c. System Controller:
2. From the front of the rack, squeeze the slide-rail locks (with green plastic
handles) to release the lock and pull the server about 1.5 inches from the rack.
3. Push the green plastic tabs on the middle slide rails to release the first stop.
4. Push the green plastic tabs on the middle slide rails to release the second stop
and pull the server out about 36 inches (about 90 cm) from the rack.
5. If you need to lighten the server, open the disk drive access cover and remove
the disk drives.
See
6. Slide the server completely out of the slide rails and place on a clean, stable
surface.
3-12
Sun Fire X4500/X4540 Server Service Manual • May 2010
To remove power supplies, see
page
3-43.
To remove the cable management assembly if necessary. See one of the
following docs depending on your CMA version:
i. Sun Fire X4500/X4540 Installation Guide
ii. Sun X4500-J Slide Rail Installation Guide (X4500)
"Early-Production Slide Rail and CMA Information" on page G-1
To remove the system controller, see
on page
3-68.
"To Remove the Drives Access Cover" on page
"To Remove a Power Supply (CRU)" on
"Replacing the System Controller (FRU)"
3-13.
(X4500)
Advertisement
Table of Contents
