Table of Contents
Advertisement
2. Power down the server. Type:
-> stop /SYS (for a Graceful shutdown as defined in
-> stop -f /SYS (for an Emergency Shut as defined in
2.7
Removing the Server Top Cover
Servicing some components requires you to remove the top cover from the server.
Caution – Removing the top cover without properly powering down the server and
disconnecting the AC power cords from the power supplies will result in a chassis
intrusion switch failure. This failure causes the server to be immediately powered off.
Any changes you make to the memory riser or DIMM configurations will not be
properly reflected in the service processor's inventory until you replace the top cover.
▼ Remove the Server Top Cover
1. Ensure that the AC power cords are disconnected from the server power
supplies.
2. To unlatch the server top cover, insert your fingers under the two cover latches
and simultaneously lift both latches in an upward motion (
2-8
Sun Server X2-4 Service Manual • April 2013
)
TABLE 2-1
)
TABLE 2-1
)[1].
FIGURE 2-4
Advertisement
Chapters
Table of Contents
