Changing The User Password; Configuring The Network; Network Interfaces - Juniper NETWORK AND SECURITY MANAGER NSM3000 - QUICK START REV 1 Quick Start Manual

Hide thumbs Also See for NETWORK AND SECURITY MANAGER NSM3000 - QUICK START REV 1:

Table of Contents

Changing the User Password

To change the user password, select System Administration > Change User Password,

fill out the form shown in Figure 24 on page 23, and then click Change.

Figure 24: Change User Password

To access options that allow you to configure the network, select System Administration

> Network Configuration. The Network Configuration window appears as shown in Figure

25 on page 23.

Figure 25: Network Interfaces Options

The following sections describe each of the options available in the Network Configuration

window:

Network Interfaces on page 23

Routing and Gateways on page 24

Hostname and DNS Clients on page 24

Host Addresses on page 25

Use this option to manage the network interfaces. See Figure 26 on page 24.

Managing System Administration

Table of Contents

Do you have a question about the NETWORK AND SECURITY MANAGER NSM3000 - QUICK START REV 1 and is the answer not in the manual?