Installing The Nsm3000 Hardware - Juniper NETWORK AND SECURITY MANAGER NSM3000 - QUICK START REV 1 Quick Start Manual

Installing the NSM3000 Hardware

Copyright © 2010, Juniper Networks, Inc.
Table 1: Required Ports on NSM3000 (continued)
Direction Port Description
Out 22 SSH connection to new managed
device
23 Telnet connection to new
managed device
53 DNS lookups
80 System Security Updates from
Juniper Networks
111 Shared Disk portmap lookup
123 Network Time Protocol (NTP) time
synchronization
2049 Shared Disk NFS connection
For more information on ports, refer to the Network and Security Manager Installation
Guide.
Follow these steps to unpack the NSM3000 appliance and connect it to your network.
To install NSM3000:
Place the shipping container on a flat surface and remove the hardware components
1.
with care.
Remove the NSM3000 device from the shipping container and place it on a flat
2.
surface.
Mount NSM3000 in your server rack using the attached mounting brackets.
3.
Plug the power cord into the AC receptacle on the rear panel.
4.
Figure 1: Rear Panel of NSM3000
Fan 0
LAN
Yes
Yes
Yes
No
Yes
Yes
Yes
Fan 1 AC Power
switch
Hardware Installation
Depends on
Internet Configuration
Yes No
No Yes
No No
Yes Yes
No Yes
Yes Yes
No Yes
Blank power
supply tray
Power
AC Power
supply supply
receptacle
5