Juniper NETWORK AND SECURITY MANAGER NSM3000 - QUICK START REV 1 Quick Start Manual page 6

NSM3000 Quick Start
6
If your NSM3000 contains two power supplies, plug a power cord into each AC
receptacle.
Plug the other end of the power cord into a wall socket.
5.
If your NSM3000 contains two power supplies, plug each power cord into a separate
power circuit to ensure that the NSM3000 continues to receive power if one of the
power circuits fails.
Plug the Ethernet cable into the port marked ETH0 on the front panel.
6.
Figure 2: Front Panel of NSM3000
USB
port
CONSOLE ETH3
Power Hardware
LED LED
Console
Hard disk LED
port
Plug the null modem serial cable into the console port.
7.
This cable was shipped with your NSM3000. If you do not have this cable, use any
other null modem serial cable.
Push the power button in the upper left corner of the front panel.
8.
The green LED below the power button turns on. The NSM3000 hard disk LED turns
on whenever the appliance reads data from or writes data to an NSM3000 hard disk.
The internal port uses two LEDs to indicate the LAN connection status, which is described
in Table 2 on page 6.
Table 2 on page 6 provides LED information for the Ethernet ports.
Table 2: Ethernet Port LEDs
LAN Status
10 Mbps connection
100 Mbps connection
1000 Mbps connection
Data is being transferred
No connection
Hard disk Hard disk
Activity LED Failure LED
ETH2 ETH1 ETH0
Ethernet
ports
LED 1
Off
Green
Orange
Orange, Green, or Off
Off
LED2
Off
Off
Off
Blinking
Off
Copyright © 2010, Juniper Networks, Inc.