Juniper NETWORK AND SECURITY MANAGER NSM3000 - QUICK START REV 1 Quick Start Manual page 12

NSM3000 Quick Start
12
On the NSM Configuration Main Menu, click Menu next to High Availability to access
1.
HA options. See Figure 5 on page 12.
Figure 5: High Availability Options
Use the High Availability option
2.
Use the
3. Primary Status
or secondary server in the HA cluster. If you select y, it is the primary server (the default).
If you select n, it is the secondary server.
Use the HA Remote IP option to enter the IP address for the HA peer in the HA cluster.
4.
Use the
HA Link Failure Detection IP
5.
outside the HA cluster that you can ping to verify connection status.
Use the HA Inter-server password
6.
the primary and secondary servers.
Click Submit to save the changes.
7.
Click Menu next to Shared Disk (see Figure 5 on page 12) to configure a shared disk
8.
for regional servers (see Figure 6 on page 13) or for central managers (see Figure 7
on page 13.) This step is optional.
to turn HA on (y) or off (n). The default is off.
option to set your NSM3000 appliance as either the primary
option to enter the IP address of a computer
option to enter the heartbeat password used between
Copyright © 2010, Juniper Networks, Inc.