Juniper MEDIA FLOW CONTROLLER 2.0.4 Installation Manual page 43

Media Flow Controller and Media Flow Manager Installation Guide
1. Reboot the machine in PXE boot mode. The PXE boot prompt is displayed.
2. Type in the label that you configured in the PXE server for the Media Flow Manager
installation boot files (for example, mfm-2.1.0) and press Enter. If installing from a serial
console, you are prompted to log in as root first.
3. Log in as root. The system configuration prompt is displayed.
4. Type the following command to get the Juniper Networks Media Flow Manager image file
installed.
Manager, not Media Flow Controller.
install-mfc <URL_of_image_file>
The end-user license agreement (EULA) is displayed.
5. Type yes to proceed. You can also type no, in which case the installation is cancelled; or
again to see the EULA again.
The following message is displayed:
Installation is done at <number>
6. Reboot by typing reboot. When prompted for build choice, do nothing; this brings up the
Media Flow Manager platform now on the local disk.
7. Log in as User admin; there is no default password.
8. Sanity check: From another machine attempt to ping each address, and open an SSH
session to the server as Admin.
Continue with
You are now ready to begin configuring Media Flow Manager. See the Juniper Networks
Media Flow Manager Administrator's Guide and CLI Command Reference.
Even though the command uses the abbreviation "mfc" it is for Media Flow
Note!
""Setting Up Basic System Connectivity" on page
CHAPTER 5 Installing Media Flow Manager
Installing Media Flow Manager from Network—PXE
33,".
43