Juniper MEDIA FLOW CONTROLLER 2.0.4 Installation Manual page 39

Media Flow Controller and Media Flow Manager Installation Guide CHAPTER 4 Installing Media Flow Controller with
4. Enter 3. If the files are accessible, this message is displayed followed by the end-user
license agreement (EULA) :
Ready to install from <URL_you_entered>
Enter 1 to Read the EULA agreement and continue with installation.
Enter 2 to Reboot without installing or restoring.
Enter 3 to Halt without installing or restoring.
Enter 1, 2, or 3 :
5. Enter 1. The EULA is displayed and then this menu. You can press the Space bar to page
through the EULA or you can enter q (the single letter "q") to jump to the end of the EULA.
Enter 1 to Read the EULA agreement again.
Enter 'accept' to accept the EULA agreement and continue with
installation.
Enter 2 to Reboot without installing or restoring.
Enter 3 to Halt without installing or restoring.
Enter 1, 2, 3, or 'accept' : accept
6. Enter accept. The following menu is displayed (options 1 and 2 and the Note are omitted
if you set init-cache or keep-cache in the PXE configuration file; see
Options" on page
Enter 1 to Install Media Flow Controller.
Enter 2 to Restore Media Flow Controller.
Enter 3 to Reboot without installing or restoring.
Enter 4 to Halt without installing or restoring.
Or enter special options as instructed by support personnel.
Note:
Install will delete all cached data.
Restore attempts to keep cached data.
Enter 1, 2, 3 or 4 :
7. If this is a first time installation, enter 1. If you have set both auto-eth and auto-reboot in
the PXE configuration file, the system reboots now using the assignment you made with
the ethsetup command; see
If this is NOT a first time installation, but you want to erase all the cached data, enter 1.
If this is NOT a first time installation, and you want to preserve cached data, enter 2. In
some situations some or all of the cached data still might not be preserved.
The installation proceeds; it can take 10 minutes or longer depending on how many disks
Media Flow Controller needs to format. When completed, the following menu is displayed.
(Options 3 through 6 are omitted if you set an ethsetup option in the PXE configuration
file; see
Installation is done at <number>
>>> Phase 1 Installation Done <<<
Enter 1 to Reboot to complete the installation.
Enter 2 to Halt. Installation will continue when rebooted.
Enter 3 to Flash ethernet port LEDs.
Enter 4 to Configure ethernet names interactively.
Enter 5 to Specify device for eth0 and eth1.
Enter 6 to Reset ethernet naming back to default.
Enter 7 to Use the PXE-boot interface for eth0.
37):
"PXE Installation Options" on page
(<MAC_address_of_eth0)
Installing Media Flow Controller Software from the Network—PXE
"PXE Installation Options" on page
37):
"PXE Installation
37.
39