Juniper MEDIA FLOW CONTROLLER 2.0.4 Installation Manual page 40

Hide thumbs Also See for MEDIA FLOW CONTROLLER 2.0.4:
Table of Contents

Advertisement

CHAPTER 4 Installing Media Flow Controller with PXE
8. If option 7 is the correct interface for eth0 (management interface), and you want all the
other interfaces to be automatically assigned, enter 7.
If option 7 is NOT the correct interface for eth0, you must manually assign the correct
interface (most systems need the interface names assigned manually). The Ethernet
naming default is based on the device's PCI bus address order and often are not optimally
assigned. It is very important that eth0 be assigned to the proper port. Use options 4 or 5
to configure the interface naming. See
The interface assignments are displayed and the installation menu reappears. (Options 3
through 6 are omitted if you set an ethsetup option in the PXE configuration file; see
Installation Options" on page
Enter 1 to Reboot to complete the installation.
Enter 2 to Halt. Installation will continue when rebooted.
Enter 3 to Flash ethernet port LEDs.
Enter 4 to Configure ethernet names interactively.
Enter 5 to Specify device for eth0 and eth1.
Enter 6 to Reset ethernet naming back to default.
Enter 7 to Use the PXE-boot interface for eth0.
9. If the interface assignments are correct, enter 1 to reboot and finish the installation.
The installation completes and an "unconfigured" prompt is displayed:
mfc-unconfigured-8a4990 login:
Continue with
40
Installing Media Flow Controller Software from the Network—PXE
(<MAC_address_of_eth0)
""Setting Up Basic System Connectivity" on page
Media Flow Controller and Media Flow Manager Installation
"Ethernet Naming Options" on page
37):
33,".
Copyright © 2010, Juniper Networks, Inc.
25, for details.
"PXE

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MEDIA FLOW CONTROLLER 2.0.4 and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents