Juniper MEDIA FLOW CONTROLLER 2.0.4 Installation Manual page 28

CHAPTER 3 Installing Media Flow Controller with a CD or USB
d: Flash the LED for 64 seconds
e: Flash the LED for 128 seconds
The eth number you want for the name of this device.
> 11
PCI address: 0000:04:00.0
inet addr: 172.12.172.238
Broadcom Corporation NetXtreme BCM5721 Gigabit Ethernet PCI Express (rev 11)
Currently assigned name: eth10
Enter one of the following:
a: Keep the current name (eth10)
b: Flash the LED for 4 seconds
c: Flash the LED for 16 seconds
d: Flash the LED for 64 seconds
e: Flash the LED for 128 seconds
The eth number you want for the name of this device.
> 0
PCI address: 0000:05:00.0
Broadcom Corporation NetXtreme BCM5721 Gigabit Ethernet PCI Express (rev 11)
Currently assigned name: eth11
Enter one of the following:
a: Keep the current name (eth11)
b: Flash the LED for 4 seconds
c: Flash the LED for 16 seconds
d: Flash the LED for 64 seconds
e: Flash the LED for 128 seconds
The eth number you want for the name of this device.
> 1
Done specifying the device to eth number mapping.
The new mapping is:
0000:04:00.0,00:13:72:3C:33:56 eth0
0000:05:00.0,00:13:72:3C:33:57 eth1
0000:01:00.0,00:15:17:8A:49:90 eth10
0000:01:00.1,00:15:17:8A:49:91 eth11
Use this mapping? (y/n) y
Saving...
Enter 1 to Reboot to complete the installation.
Enter 2 to Halt. Installation will continue when rebooted.
Enter 3 to Flash ethernet port LEDs.
Enter 4 to Configure ethernet device names interactively.
Enter 5 to Specify devices to use for eth0 and eth1.
Enter 6 to Reset ethernet device naming back to default.
Enter 1, 2, 3, 4, 5 or 6 :
28 Ethernet Naming Options
Media Flow Controller and Media Flow Manager
HW addr: 00:13:72:3C:33:56
HW addr: 00:13:72:3C:33:57
Copyright © 2010, Juniper Networks, Inc.