Juniper MEDIA FLOW CONTROLLER 2.0.4 Installation Manual page 21

Media Flow Controller and Media Flow Manager Installation Guide
To upgrade your system using the CLI:
1. From Enable or Configure mode, fetch the configuration upgrade image file with the
Juniper Networks URL.
image fetch <URL>/<filename>
2. Install the image.
image install <filename>
3. Verify which boot image contains the upgrade.
show images
4. Switch to the boot partition containing the upgrade image, if needed.
boot system next
5. Verify that the correct partition is set to boot.
show images
6. Reboot to that partition.
reload
7. Verify that the new image is booted.
show version
Example:
test-vos-cl130 (config) # image fetch http://123.45.678.9/mfg/mfc-2.1.0-rc-
latest/image-mfc-2.1.0-rc-1_11818_184.img
100.0%
test-vos-cl130 (config) # image install ?
<image filename>
image-mfc-2.1.0-rc-1_11818_184.img
test-vos-cl130 (config) # image install image-mfc-2.1.0-rc-1_11818_184.img
Step 1 of 4: Verify Image
100.0%
Step 2 of 4: Uncompress Image
100.0%
Step 3 of 4: Create Filesystems
100.0%
Step 4 of 4: Extract Image
100.0%
test-vos-cl130 (config) #
test-vos-cl130 (config) # show image
Images available to be installed:
image-mfc-2.1.0-rc-1_11818_184.img
mfc-2.1.0-rc 1_11818_184
Installed images:
Partition 1:
mfc-2.0.2-rc 73_10732_170
Partition 2:
mfc-2.1.0-rc 1_11818_184
Last boot partition: 1
Next boot partition: 1
No boot manager password is set.
No image install currently in progress.
OR
image boot next
[#################################################################]
[#################################################################]
[#################################################################]
[#################################################################]
[#################################################################]
CHAPTER 2 Getting Started
Upgrading and Rebooting 21