Juniper MEDIA FLOW CONTROLLER 2.0.4 Installation Manual page 17

Media Flow Controller and Media Flow Manager Installation Guide
Eth 0 and Eth 1 are onboard interfaces whereas Eth 2-5 traffic port recommendations are Intel
Pro/1000 PT/VT dual- or quad-port NIC for GbE. These are the minimum TCP/UDP port
requirements; other ports can be opened up on an as-needed basis. By default, the Media
Flow Controller management port is 8080.
The installation procedure provides several options for correctly identifying and naming
Note!
the Ethernet interfaces. See
Controller with a CD or USB for details.
traffic
Eth 2, 3, 4...
HTTP (80)
Switch
Internet
User
User
Figure 1 Example Connectivity
Table 3 Example Machine Setup of Management and Traffic Ports
Interface Connectivity IP Address Subnet Mask
Eth 0 onboard
Eth 1 onboard
Eth 2 PCIe card
Eth 3 PCIe card
Eth 4 PCIe card
Eth 5 PCIe card
*Eth0 AND Eth1 can be on the same subnet; this examples indicates they are not.
Ethernet Naming Options
Media Flow Controller
Origin
Server
User
192.168.1.100 255.255.255.0 192.168.1.1
172.20.46.10* 255.255.255.0 not applicable
10.1.1.11 255.255.255.0 not applicable
10.1.2.11 255.255.255.0 not applicable
10.1.3.11 255.255.255.0 not applicable
10.1.4.11 255.255.255.0 not applicable
in Chapter 3, "Installing Media Flow
Terminal server console
origin fetch
Eth 1
HTTP (80)
Switch
HTTP
Intranet/
Internet
NFS
Origin
Server
Open
Gateway
Ports
8080, 22
80
80
80
80
80
Example: Machine Setup
CHAPTER 2 Getting Started
management
Eth0
HTTP (8080)
SSH (22)
Management VLAN
Management station
Internet
Purpose
Access
yes Management
yes Origin fetch
not Traffic
applicable
not Traffic
applicable
not Traffic
applicable
not Traffic
applicable
17