CHAPTER 5 Installing Media Flow Manager
Before Installing Media Flow Manager
The procedure for installing Media Flow Manager is very different from that for installing Media
Flow Controller. However, much of the information in the previous chapters of this book apply,
with the exception of the cache directives and Ethernet naming guidelines (Media Flow
Manager does not handle traffic, it is only a management device). If necessary, review this
information:
•
"Pre-installation Planning" on page 14
•
"Upgrading and Rebooting" on page 19
•
"Creating CDs" on page 25
•
"Before Installing Media Flow Controller with PXE" on page
Installing Media Flow Manager—CD-ROM/USB
When the Media Flow Manager software is installed, it reformats the root drive in the system.
While the software is installing, at times no progress indicator is given while formatting the
drives. Please be patient.
1. Put in the CD-ROM, or plug in the USB drive, and reboot the machine from the installation
media.
2. Type the following command to get the Media Flow Manager image file installed.
using PXE, follow this command with the URL of the image file.
install-mfm
The end-user license agreement (EULA) is displayed.
3. You must type yes to proceed. You can also type no, in which case the installation is
cancelled; or again to see the EULA again. The following message is displayed:
Installation is done at <number>
4. Reboot by typing reboot. When prompted for build choice, do nothing; this brings up the
Media Flow Manager platform now on the local disk. The installation completes and an
"unconfigured" prompt is displayed:
mfc-unconfigured-8a4990 login:
Finish with
Installing Media Flow Manager from Network—PXE
You must have a configured PXE server (see
URL of the Juniper Networks Media Flow Manager software image in order to use this
procedure. To obtain the Media Flow Manager install package, contact Juniper Networks
Support; see
Before you begin: Plug your machine into a serial console, with flow control disabled, and
configure your BIOS to PXE boot. We recommend connecting the console to the terminal
server and opening a TELNET session for this procedure.
42
Before Installing Media Flow Manager
Media Flow Controller and Media Flow Manager Installation Guide
"Setting Up Basic System Connectivity" on page 33.
"Requesting Technical Support" on page
35.
"Setting Up PXE Overview" on page
11.
Copyright © 2010, Juniper Networks, Inc.
If
Note!
35) and the
Need help?
Do you have a question about the MEDIA FLOW CONTROLLER 2.0.4 and is the answer not in the manual?