Juniper JUNOSE 11.2.X MULTICAST ROUTING Configuration Manual page 57

show ip mroute summary
show ip multicast protocols
Copyright © 2010, Juniper Networks, Inc.
Forwarded : 0 pkts, 0 bytes
Rcvd on OIF: 0 pkts
Counts: 1 (S, G) entries
0 (*, G) entries
See show ip mroute.
See statistics.
Use to display a summary of all or specified multicast routes.
Specify a multicast group IP address or both a multicast group IP address and a
multicast source IP address to display information about a particular multicast
forwarding entry.
Field descriptions
Group Address—IP address of the multicast group
Source Address—IP address of the multicast source
RPF route—IP address and network mask of the RPF route
RPF Iif —Type and identifier for the incoming interface for the RPF route
#Oifs—Number of outgoing interfaces
Counts—Numbers of types of (S,G) pairs
(S,G)—Number of (S,G) entries
(* ,G)—Number of (* ,G) entries
Example
host1#show ip mroute summary
IP Multicast Routing Table
Group Address Source Address
--------------- --------------- ---------
224.0.1.39 52.1.1.1
224.0.1.40 51.1.1.1
Counts: 2 (S, G) entries
0 (*, G) entries
See show ip mroute.
Use to display information about multicast protocols enabled on the router.
Use the brief option to display a summary of information rather than a detailed
description.
Field descriptions
Chapter 1: Configuring IPv4 Multicast
RPF route RPF Iif
-------------
51.1.1.1/32 Register IIF
51.1.1.1/32 loopback1
#Oifs
----
0
1
35