Juniper JUNOSE 11.2.X MULTICAST ROUTING Configuration Manual page 189

Copyright © 2010, Juniper Networks, Inc.
Incoming interface list—List of incoming interfaces on the router. Details include:
Type of interface and its specifier
Action that the interface takes with packets: accept or discard
Multicast protocol that owns the interface
Time that the interface has been active in this multicast forwarding entry, in days
hours:minutes:seconds format
Time that the interface will cease to be active in this multicast forwarding entry,
in days hours:minutes:seconds format
Outgoing interface list—List of outgoing interfaces on the router. Details include:
Type of interface and its specifier
Action that the interface takes with packets: forward
Protocol running on the interface: PIM or MLD
Time that the interface has been active in this multicast forwarding entry, in days
hours:minutes:seconds format
Time that the interface will cease to be active in this multicast forwarding entry,
in days hours:minutes:seconds format
Counts—Numbers of types of source group mappings
(S,G)—Number of (S,G) entries
(* ,G)—Number of (* ,G) entries
Example
host1#show ipv6 mroute
IP Multicast Routing Table
(S, G) uptime d h:m:s[, expires d h:m:s]
[Admission bandwidth: bps]
[QoS bandwidth: bps]
RPF route: addr/mask, incoming interface
neighbor address, owner route-owner
Incoming interface list:
Interface (addr/mask), State/Owner [(RPF IIF)]
Outgoing interface list:
Interface (addr/mask), State/Owner, Uptime/Expires
(10:0:0:1:1::, ff0e::1) uptime 0 01:04:12
RPF route: 10:0:0:1::/64, incoming interface ATM2/3.1001
neighbor 10:0:0:1::1, owner Local
Incoming interface list:
ATM2/3.1001 (10:0:0:1::1/64), Accept/Pim (RPF IIF)
Outgoing interface list:
ATM2/0.200 (21:2:2:21::2:1/60), Forward/Pim, 0 01:04:12/never
(10:0:0:1:2::, ff0e::1) uptime 0 01:04:12
RPF route: 10:0:0:1::/64, incoming interface ATM2/3.1001
neighbor 10:0:0:1::1, owner Local
Chapter 5: Configuring IPv6 Multicast
167