Juniper JUNOSE 11.1.X MULTICAST ROUTING Configuration Manual page 196

JUNOSe 11.1.x Multicast Routing Configuration Guide
show ipv6 mroute active
174
Monitoring IPv6 Multicast Settings
Outgoing interface list List of outgoing interfaces on the router. Details
include:
Type of interface and its specifier
Action that the interface takes with packets: forward
Protocol running on the interface: PIM or MLD
Time that the interface has been active in this multicast forwarding
entry, in days hours:minutes:seconds format
Time that the interface will cease to be active in this multicast forwarding
entry, in days hours:minutes:seconds format
Counts Numbers of types of source group mappings
(S,G) Number of (S,G) entries
(*,G) Number of (*,G) entries
Example
host1#show ipv6 mroute
IP Multicast Routing Table
(S, G) uptime d h:m:s[, expires d h:m:s]
[Admission bandwidth: bps]
[QoS bandwidth: bps]
RPF route: addr/mask, incoming interface
neighbor address, owner route-owner
Incoming interface list:
Interface (addr/mask), State/Owner [(RPF IIF)]
Outgoing interface list:
Interface (addr/mask), State/Owner, Uptime/Expires
(10:0:0:1:1::, ff0e::1) uptime 0 01:04:12
RPF route: 10:0:0:1::/64, incoming interface ATM2/3.1001
neighbor 10:0:0:1::1, owner Local
Incoming interface list:
ATM2/3.1001 (10:0:0:1::1/64), Accept/Pim (RPF IIF)
Outgoing interface list:
ATM2/0.200 (21:2:2:21::2:1/60), Forward/Pim, 0 01:04:12/never
(10:0:0:1:2::, ff0e::1) uptime 0 01:04:12
RPF route: 10:0:0:1::/64, incoming interface ATM2/3.1001
neighbor 10:0:0:1::1, owner Local
Incoming interface list:
ATM2/3.1001 (10:0:0:1::1/64), Accept/Pim (RPF IIF)
Outgoing interface list:
ATM2/0.200 (21:2:2:21::2:1/60), Forward/Pim, 0 01:04:12/never
Counts: 2 (S, G) entries
0 (*, G) entries
See show ipv6 mroute.