Configuring Pim For Ipv6 Multicast; Overview - Juniper JUNOSE 11.1.X MULTICAST ROUTING Configuration Manual

Chapter 7

Configuring PIM for IPv6 Multicast

Overview

Protocol Independent Multicast (PIM) is a collection of multicast routing protocols
that enable multicast routers to identify other multicast routers that can receive
packets.
This chapter describes how to configure PIM for IPv6 multicast on the E Series router;
it contains the following sections:
Overview on page 215
Platform Considerations on page 218
References on page 218
Before You Begin on page 219
Enabling and Disabling PIM on a VR on page 219
Enabling PIM on an Interface on page 220
Setting a Priority to Determine the Designated Router on page 220
Configuring the PIM Join/Prune Message Interval on page 221
Configuring an RP Router for PIM Sparse Mode on page 222
Configuring BSR and RP Candidates for PIM Sparse Mode on page 222
Switching to an SPT for PIM Sparse Mode on page 224
Configuring PIM Sparse Mode Remote Neighbors on page 224
Using PIM Sparse Mode Join Filters on page 226
Configuring PIM SSM on page 227
Configuring the BFD Protocol for PIM on page 229
Removing PIM on page 230
Resetting PIM Counters and Mappings on page 230
Monitoring PIM on page 231
This implementation of PIM supports PIM sparse mode and PIM source-specific
multicast (PIM SSM) for IPv6 multicast.
215
Overview