Juniper JUNOSE 11.1.X MULTICAST ROUTING Configuration Manual page 159

show ip dvmrp
Use to set the counters for DVMRP statistics to zero, which establishes a reference
point, or baseline, for DVMRP statistics.
Example
(host1)#baseline ip dvmrp
There is no no version.
See baseline ip dvmrp.
Use to display DVMRP information for a VR.
Field descriptions
Dvmrp Administrative State State of DVMRP in the software: Enabled or
Disabled
Mcast Administrative State State of multicasting in the software: Enabled
or Disabled
Dvmrp Version Version of DVMRP with which this software is compatible
GenerationID A number the router generates each time it reboots; when
the number changes, neighbors discard all information previously learned
from the router
Number of Routes Number of routes in the DVMRP routing table
Number of Triggered Routes Number of routes waiting to be advertised,
because a parameter for the route changed
Reachable Routes Number of routes that the router can currently reach
Route-hog-notification Number of DVMRP routes that the router can record
before it generates a system log warning message
Route-limit Maximum number of routes that the router can advertise on
each interface
Send-S32-Prunes-Only Indicator of whether the router sends only S-32
prunes
true Router sends only S-32 prunes and grafts to ensure compatibility
with other protocols, such as PIM
false Router sends S-32 and S/Prefix grafts and prunes
Example
host1:boston>show ip dvmrp
Routing Process DVMRP - Distance Vector Multicast Routing Protocol
Dvmrp Administrative State:
Multicast Administrative State:
Dvmrp Version:
Generation ID:
Number of Routes:
Number of Triggered Routes:
Chapter 4: Configuring DVMRP
Enabled
Enabled
3.255
0x46828e2b
2
0
Monitoring DVMRP
137