Before You Begin; Enabling Pim On A Vr; Disabling Pim On A Vr - Juniper JUNOSE 11.1.X MULTICAST ROUTING Configuration Manual

NOTE: IETF drafts are valid for only 6 months from the date of issuance. They must
be considered as works in progress. Please refer to the IETF Web site at
http://www.ietf.org for the latest drafts.

Before You Begin

You can configure PIM on IPv4 and IPv6 interfaces. However, IPv6 does not support
all PIM configuration options. For information about configuring PIM on IPv6
interfaces, see "Configuring PIM for IPv6 Multicast" on page 215.

Enabling PIM on a VR

By default, PIM is disabled. To enable PIM on a VR:
1.
2.
3.
router pim

Disabling PIM on a VR

To disable PIM processing on a router, use the pim disable command.
pim disable
Enable multicast routing. (See "Enabling IP Multicast" on page 7.)
Create a VR, or access an existing VR context.
host1(config)#virtual-router boston
Create and enable PIM processing.
host1:boston(config)#router pim
Use to create and enable PIM processing on a VR or to access Router
Configuration mode.
Example
host1:boston(config)#router pim
Use the no version to remove PIM from the VR.
See router pim.
Use to disable PIM processing. By default, PIM processing is enabled.
Example
host1:boston(config-router)#pim disable
Chapter 3: Configuring PIM for IPv4 Multicast

Before You Begin

87