Juniper JUNOS SOFTWARE 10.2 - SOFTWARE INSTALLATION AND UPGRADE GUIDE 4-28-2010 Upgrade Manual page 89

From the CLI, enter the
Action
Sample Output user@router> show system license
License usage:
Licenses installed:
The output shows a list of the license usage and a list of the licenses installed on the
Meaning
router. Verify the following information:
NOTE: A state of
it was entered incorrectly or it is not valid for the specific device.
Displaying License Usage
Verify that the licenses fully cover the feature configuration on the router.
Purpose
From the CLI, enter the
Action
show system license
Licenses
Feature name used
subscriber-acct 0
subscriber-auth 0
subscriber-addr 0
subscriber-vlan 0
subscriber-ip 0
scale-subscriber 0
scale-l2tp 0
scale-mobile-ip 0
License identifier: E000185416
License version: 2
Features:
subscriber-acct - Per Subscriber Radius Accounting
permanent
subscriber-auth - Per Subscriber Radius Authentication
permanent
subscriber-addr - Address Pool Assignment
permanent
subscriber-vlan - Dynamic Auto-sensed Vlan
permanent
subscriber-ip - Dynamic and Static IP
permanent
Each license is present. Licenses are listed in ascending alphanumeric order by
license ID.
The state of each license is
invalid indicates that the license key is not a valid license key. Either
The feature for each license is the expected feature. The features enabled are
listed by license. An all-inclusive license has
All configured features have the required licenses installed. The
column must show that no licenses are required.
show system license usage
Chapter 7: Managing JUNOS Software Licenses
command.
Licenses Licenses
installed needed
1 0
1 0
1 0
1 0
1 0
1000 0
1000 0
1000 0
permanent .
All features
command.
Displaying License Usage
Expiry
permanent
permanent
permanent
permanent
permanent
permanent
permanent
permanent
listed.
Licenses needed
67