Table 5: Junos Software Feature Licenses - Juniper JUNOS SOFTWARE 10.2 - SOFTWARE INSTALLATION AND UPGRADE GUIDE 4-28-2010 Upgrade Manual

Hide thumbs

Table Of Contents

Table of Contents

JUNOS Release 10.2 Software Installation and Upgrade Guide

NOTE: Configurations might include both licensed and nonlicensed features. For

these situations, the license is enforced up to the point where the license can be

clearly distinguished. For example, an authentication-order configuration is shared

by both Authentication, Authorization, and Accounting (AAA), which is licensed, and

by Layer 2 Tunneling Protocol (L2TP), which is not licensed. When the configuration

is committed, the router does not issue any license warnings, because it is not yet

known whether AAA or L2TP is using the configuration. However, at runtime, the

router checks for a license when AAA authenticates clients, but does not check when

L2TP authenticates clients.

The router reports any license breach as a warning log message whenever a

configuration is committed that contains a feature or scale limit usage that requires

a license. Following the 30-day grace period, the router periodically reports the breach

to the CLI command line until a license is installed and properly configured on the

router to resolve the breach.

NOTE: Successful commitment of a licensable feature or scaling configuration does

not imply that the required licenses are installed or not required. If a required license

is not present, the system issues a warning message after it commits the configuration.

Software Feature Licenses

Each license is tied to one software feature pack or scaling level, and that license is

valid for only one router. Table 5 on page 62 lists the software features, their current

level of support, and the license name.