Table of Contents
Advertisement
JUNOS Release 10.2 Software Installation and Upgrade Guide
NOTE: On MX80 routers, the Routing Engine is a built-in device and has no model
number. The dual internal NAND flash devices are
device is
To view the storage media currently available on your system, use the CLI
system storage
CLI User's Guide.
Boot Sequence (M Series, MX Series, T Series, TX Matrix, and TX Matrix Plus Routers)
tThe M Series, MX Series (except for the MX80 routers), T Series, and TX Matrix
routers attempt to boot from the storage media in the following order:
1.
2.
3.
MX80 routers attempt to boot from the storage media in the following order:
1.
2.
The TX Matrix Plus router attempts to boot from the storage media in the following
order:
1.
2.
3.
4.
NOTE: Do not insert the removable media during normal operations. The router does
not operate normally when it is booted from the removable media.
If the router boots from an alternate boot device, the JUNOS Software displays a
message indicating this when you log in to the router. For example, the following
message shows that the software booted from the hard disk (/
18
Boot Sequence (M Series, MX Series, T Series, TX Matrix, and TX Matrix Plus Routers)
.
da2
command. For more information about this command, see the JUNOS
Removable media
CompactFlash card (if available)
Hard disk
USB media
Dual, internal NAND flash device (first
USB media
CompactFlash card (if available)
Disk 1
Storage media available on the LAN
login: username
Password: password
Last login: date on terminal
--- JUNOS 8.0 R1 built date
---
--- NOTICE: System is running on alternate media device (/dev/ad2s1a).
da0
and
da1
. The USB storage
da0
, then
da1
)
dev/ad2s1a
show
):
Advertisement
Table of Contents
