Juniper JUNOS SOFTWARE 10.2 - SOFTWARE INSTALLATION AND UPGRADE GUIDE 4-28-2010 Upgrade Manual page 80

JUNOS Release 10.2 Software Installation and Upgrade Guide
4.
5.
58
Load and Commit the Configuration File
user@host# commit
commit complete
Exit the CLI configuration mode.
user@host# exit
user@host>
Back up the JUNOS Software.
After you have installed the software on the router, committed the configuration,
and are satisfied that the new configuration is successfully running, issue the
command to back up the new software to the
request system snapshot
file system. If you do not issue the
configuration on the alternate boot drive will be out of sync with the configuration
on the primary boot drive.
The
request system snapshot
up to /altroot , and /config
systems are on the router s CompactFlash card, and the
file systems are on the router s hard disk.
request system snapshot
command causes the root file system to be backed
to be backed up to /altconfig
/altconfig
command, the
. The root and /config file
and
/altroot /altconfig